Sublimation comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2026-03-25. Where a claim depends on a specific study, the study is described rather than over-claimed.
A typical cycle begins with freezing, which fixes the material into a solid and determines ice crystal size. Primary drying then raises heat under vacuum so ice sublimes, often near or below the collapse temperature of the formulation. Secondary drying removes bound water that remains after ice is gone, usually by gently warming the product. Each stage balances heat input against pressure to avoid melting or structural damage. Temperature probes and pressure sensors guide the transition between stages.
In practice, lyophilization is slower and more energy intensive than simple drying. Cycle times can range from hours to several days depending on load, container, and formulation. Amorphous materials may require excipients that help preserve structure during freezing and drying. The method is widely used for biological materials, pharmaceuticals, and foods where heat drying would cause unacceptable change. Open questions remain about scaling cycles between laboratory and production equipment, and this gap affects technology transfer.
A formulation often contains excipients that protect the active ingredient during freezing and drying. Bulking agents provide structure, while lyoprotectants stabilize sensitive molecules. The freezing step can produce ice crystals whose size and distribution affect the drying rate, and cycle design includes freezing, annealing, and drying phases. If the product temperature rises above a critical value, the cake may collapse or lose its porous structure. Successful lyophilization therefore depends on the interaction between formulation, equipment, and cycle design.
Lyophilization is a dehydration process that removes water from a frozen material by sublimation under low pressure. The material is first frozen to convert liquid water into ice. Next, the pressure is reduced below the triple point of water so that ice changes directly into vapor without passing through a liquid phase. This step is called primary drying. The result is a porous solid or cake that retains the original shape of the frozen solution.
After primary drying, secondary drying removes water that remains bound to the material. This stage raises the shelf temperature while maintaining low pressure, which encourages desorption of unfrozen water. Residual moisture can be reduced to a low percentage, improving stability for many products. The process parameters, including freezing rate, shelf temperature, and chamber pressure, influence the final pore structure and reconstitution behavior. Control of these variables helps prevent collapse or meltback during drying.
| Property | Value | Notes |
|---|---|---|
| Common synonym | Freeze-drying | Same dehydration operation |
| Typical vacuum | 10-100 Pa | Pressure during primary drying |
| Primary drying temperature | -40 to -10 °C | Below collapse temperature for many formulations |
| Cycle duration | 12-72 hours | Varies with load, container, and formulation |
| Key phase change | Sublimation | Solid ice to water vapor |
The process usually has three stages: freezing, primary drying, and secondary drying. Freezing sets the ice crystal structure and can determine pore size in the final cake. Primary drying removes free ice by sublimation at low pressure and low shelf temperature. Secondary drying removes bound water by raising the shelf temperature, although some water may remain as part of the solid. Cycle parameters depend on formulation, fill volume, vial type, and equipment performance.
The physical chemistry of freezing influences whether a formulation forms an amorphous glass or a crystalline solid. Amorphous systems can collapse if product temperature rises above the glass transition temperature of the freeze concentrate. Crystalline systems may show eutectic melting, where ice and solute melt together at a fixed temperature. Formulators add bulking agents, lyoprotectants, and buffers to preserve structure and biological activity. The optimum cycle keeps product temperature below critical thresholds during primary drying while allowing efficient sublimation.
The physics of freeze-drying couples heat transfer, mass transfer, and phase change. Heat supplied through the shelf must reach the sublimation front without melting the ice or degrading the product. Water vapor then travels through the already dried layer and leaves the chamber, where low pressure and cold traps keep it from returning. The dried layer acts as a resistance to vapor flow, so drying rate changes as the front recedes. Open questions remain about how pore structure and formulation heterogeneity affect drying uniformity at larger scales.
Lyophilization removes water from a frozen material by sublimation under reduced pressure. The process begins with freezing, which converts liquid water into ice and concentrates dissolved solids. Primary drying then lowers chamber pressure so ice changes directly into vapor without passing through a liquid phase. Secondary drying raises the shelf temperature to remove bound water that remains after ice sublimation. The result is a dry, porous structure that can be reconstituted later.
In the evening hours of 24 June 2021, a rare, violent, and deadly long-tracked tornado struck several villages in the Hodonín and Břeclav districts of the South Moravian Region of the Czech Republic, killing six people and injuring 576 others. This tornado is the widest on record in Europe, at 3.5 kilometres (2.2 mi) maximum width. The tornado struck seven municipalities, with the worst damage in the villages of Hrušky, Moravská Nová Ves, Mikulčice and Lužice. This tornado was the strongest ever documented in modern Czech history and the deadliest European tornado since 2001. It was rated as an F4 on the Fujita scale and an IF4 on the International Fujita scale. This made it the first confirmed violent (IF4+) tornado in Europe since June 2017, when an IF4 tornado struck the village of Maloye Pes'yanovo in Russia, until the 2026 Ayyasha-Çaybeyi-Akçamezra tornado on May 3rd 2026, it was the only IF4 rated tornado to occur since the scale was introduced.
Radiation therapy is usually reserved for people who have tumours remaining after surgery. These people often also receive medication to lower GH levels. Radiation therapy is given in divided doses over four to six weeks. This treatment lowers GH levels by about 50 percent over 2 to 5 years. People monitored for more than 5 years show significant further improvement. Radiation therapy causes a gradual loss of production of other pituitary hormones with time. Loss of vision and brain injury, which have been reported, are very rare complications of radiation treatments.
Across several benchmarks, AlphaFold3 has demonstrated, on average, superior performance to conventional search-based docking algorithms in predicting small-molecule–protein binding modes. AlphaFold 3 version can predict structures of protein complexes with a very limited set of selected cofactors and co- and post-translational modifications. Between 50% and 70% of the structures of the human proteome are incomplete without covalently-attached glycans. Studies have shown that although AlphaFold3 can jointly model protein–ligand co-folding, its accuracy drops markedly on test cases with low similarity to its training data—an area of particular importance for drug discovery. Other work has found that AlphaFold is insensitive to adversarial decoys generated by altering the physicochemical properties of binding pockets, suggesting potential reliance on training-set memorization rather than genuine chemical awareness.
A property of DNA is its ability to re-anneal into double-stranded molecules when pH conditions are neutralized. Under neutral conditions, hydrogen bonds reform between complementary base pairs. Because the plasmid was so tightly coiled and small before the alkaline conditions were established, it can easily re-anneal. The chromosomal DNA, however, because of its lengthy strands, does not re-anneal. Once the plasmid DNA reassociates into double-stranded molecules, it dissolves into the solution. Potassium acetate reacts with the SDS detergent, magnesium ions, and calcium ions already present in the solution and forms potassium dodecyl sulfate (KDS), an insoluble white solid which precipitates out of solution. The remaining chromosomal DNA strands, denatured proteins, and added chemicals stick together and precipitate out with the KDS. The plasmid DNA, however, remains dissolved in the liquid solution. The solution is usually centrifuged to collect the insoluble precipitates into a debris pellet at the bottom of the sample tube and thereby isolate them from the supernatant.
There has been a tremendous advance in speed and cost reduction since the completion of the Human Genome Project, with some labs able to sequence over 100,000 billion bases each year, and a full genome can be sequenced for $1,000 or less. Computers became essential in molecular biology when protein sequences became available after Frederick Sanger determined the sequence of insulin in the early 1950s. Comparing multiple sequences manually turned out to be impractical. Margaret Oakley Dayhoff, a pioneer in the field, compiled one of the first protein sequence databases, initially published as books as well as methods of sequence alignment and molecular evolution. Another early contributor to bioinformatics was Elvin A. Kabat, who pioneered biological sequence analysis in 1970 with his comprehensive volumes of antibody sequences released online with Tai Te Wu between 1980 and 1991. In the 1970s, new techniques for sequencing DNA were applied to bacteriophage MS2 and øX174, and the extended nucleotide sequences were then parsed with informational and statistical algorithms. These studies showed that well-known features, such as coding segments and the triplet code, could be revealed in straightforward statistical analyses and were proof of the concept that bioinformatics would be insightful.
Sources: en.wikipedia.org
Apitegromab, sold under the brand name Isembyld, is a fully human IgG4 lambda monoclonal antibody used for the treatment of spinal muscular atrophy. It is a recombinant monoclonal antibody targeting proforms of myostatin. The most common side effects include upper respiratory tract infections, vomiting, cough, other viral infections, headache, gastroenteritis, and pharyngitis (sore throat). Apitegromab was approved for to treat Spinal Muscular Atrophy in the United States in September 2026. Apitegromab is indicated for the treatment of spinal muscular atrophy in people aged two years of age and older who are currently receiving a survival motor neuron 2-targeted treatment.Spinal muscular atrophy is a rare, progressive neuromuscular disease affecting approximately 1 in 10,000 live births and is among the leading genetic causes of infant mortality. It is caused by a faulty survival motor neuron 1 (SMN1) gene that fails to produce a protein essential for motor neuron survival, leading to progressive muscle weakness and wasting.
The European Bioinformatics Institute (EMBL-EBI) is an intergovernmental organization (IGO) which, as part of the European Molecular Biology Laboratory (EMBL) family, focuses on research and services in bioinformatics. It is located on the Wellcome Genome Campus in Hinxton near Cambridge, and employs over 600 full-time equivalent (FTE) staff. Further, the EMBL-EBI hosts training programs that teach scientists the fundamentals of the work with biological data and promote the plethora of bioinformatic tools available for their research, both EMBL-EBI-based and not so. One of the roles of the EMBL-EBI is to index and maintain biological data in a set of databases, including Ensembl (housing whole genome sequence data), UniProt (protein sequence and annotation database) and Protein Data Bank (protein and nucleic acid tertiary structure database). A variety of online services and tools is provided, such as Basic Local Alignment Search Tool (BLAST) or Clustal Omega sequence alignment tool, enabling further data analysis.
CGRP antagonists can be used for both acute migraine treatment as well as prophylactically. CGRP is a neuropeptide which is thought to induce migraines via vasodilation of cranial arteries. CGRP can also release inflammatory agents and cause nervous system sensitization. It is theorized that by antagonizing the CGRP receptor of the trigeminal ganglia, lowered CGRP is released and less migraine occurs. Erenumab is a highly selective human monoclonal antibody which is a promising new development in migraine treatment. It has low risk of hepatoxicity like gepants can have, due to being mostly eliminated via proteolysis. There have been some studies suggesting the benefit of using melatonin for prophylaxis of migraine, however, there is a lack of strength of evidence due to a low number of studies as well as conflicting results. Melatonin has a good safety profile but there have been rare instances of serious side effects. More studies are needed in order to suggest the therapeutic use of melatonin for prophylaxis of migraine.
Alanine (symbol Ala or A), or α-alanine, is an α-amino acid that is used in the biosynthesis of proteins. It contains an amine group and a carboxylic acid group, both attached to the central carbon atom which also carries a methyl group side chain. Consequently it is classified as a non-polar, aliphatic α-amino acid. Under biological conditions, alanine exists in its zwitterionic form with its amine group protonated (as −NH+3) and its carboxyl group deprotonated (as −CO−2). Alanine is encoded by all codons starting with GC (GCU, GCC, GCA, and GCG). The L-isomer of alanine (left-handed) is the one that is incorporated into proteins. L-alanine is second only to L-leucine in rate of occurrence, accounting for 7.8% of the primary structure in a sample of 1,150 proteins. The right-handed form, D-alanine, occurs in peptides in some bacterial cell walls (in peptidoglycan) and in some peptide antibiotics, and occurs in the tissues of many crustaceans and molluscs as an osmolyte. Alanine is not an essential amino acid in humans because it can be synthesized metabolically and does not need to be present in the diet. However hypoalaninemia (alanine deficiency) is possible under certain conditions such as ketotic hypoglycemia.
Sources: en.wikipedia.org
Primary drying removes ice by sublimation under vacuum. Secondary drying removes water that is bound to the material, often by warming the product after most ice has left. Both stages occur below temperatures that would cause unwanted melting.
Sublimation requires the solvent to remain solid so vapor leaves without passing through a liquid phase. If the product melts, the porous structure can collapse and drying becomes uneven. Maintaining frozen conditions preserves the intended physical form.
No, freeze-drying is a dehydration method, not a sterilization step. It can reduce water activity and limit microbial growth during storage, but it does not reliably kill microbes or remove endotoxins. Sterility must come from separate validated processes.
Lyophilization removes water by sublimation from a frozen material, while evaporation changes liquid water into vapor. The low-pressure freezing step avoids the liquid phase and can preserve heat-sensitive structures.